PPP-NCLAuD

Cantilever data:
Property Nominal Value Specified Range
Resonance Frequency [kHz] 190 146 - 236
Force Constant [N/m] 48 21 - 98
Length [µm] 225 215 - 235
Mean Width [µm] 38 30 - 45
Thickness [µm] 7 6 - 8
Order codes and shipping units:
Order Code AFM probes per pack Data sheet
PPP-NCLAuD-10 10 of all probes
NANOSENSORS™ PointProbe® Plus AFM Probes

PointProbe® Plus Non-Contact /Tapping Mode - Long Cantilever - Au coating (Detector side)

The PointProbe® Plus (PPP) combines high application versatility and compatibility with most commercial SPMs. The typical AFM tip radius of less than 7 nm and the minimized variation in AFM tip shape provide reproducible images and enhanced resolution.

NANOSENSORS™ PPP-NCLAuD probes are designed for non-contact mode or tapping mode AFM (also known as: attractive or dynamic mode). The NCL type is offered as an alternative to NANOSENSORS™ high frequency non contact type (NCH). PPP-NCLAuD is recommended if the feedback loop of the microscope does not accept high frequencies (400 kHz) or if the detection system needs a minimum AFM cantilever length > 125 µm. Compared to the high frequency non-contact type NCH the maximum scanning speed is slightly reduced. This AFM probe type combines high operation stability with outstanding sensitivity and fast scanning ability.

The AFM probe offers unique features:

  • guaranteed AFM tip radius of curvature < 10 nm
  • AFM tip height 10 - 15 µm
  • highly doped silicon to dissipate static charge
  • Au coating on detector side of AFM cantilever
  • chemically inert

A metallic layer (Au) is coated on the detector side of the AFM cantilever which enhances the reflectivity of the laser beam by a factor of about 2.5. Furthermore it prevents light from interfering within the AFM cantilever. As the coating is nearly stress-free the bending of the AFM cantilever due to stress is less than 2 degrees.

This AFM probe features alignment grooves on the back side of the holder chip. These grooves fit to the NANOSENSORS Alignment Chip.